need help to build ak

[glockguy68]

I have a Romi G parts kit with a bent receiver with no holes,it have the plan to drill the holes glued on it,if somebody knows to drill and heat treat,and helpwith the assembly,I will be happy to pay for the party and money,PM me if someone is good to go on it.

[deth502]

i can walk you through most of it if you need guidance.

you might also want to chek out the ak forums over on gunsnet.net for alot of biy info.

by no holes, do you mean NO holes?? as in just the prebent u-channel??

they are pretty dificult, especially for a beginner to start on, imo, but not impossible.

where are you at right now in the build??

[PROVANTAGE]

if i were you i would just buy a registered one from nodak spud. i know guys that tried it and ended up waisting money.

[glockguy68]

I only need the receiver,everything is on go,have only the channel bent,,thanks,I think I will try to do the holes,and if the fit is a no go,will get one already done,thanks guys,is always good to have a 2nd op....

[deth502]

you have all of your kit demilled??

bbl is out of the front trunnion, rear rivets out, trigger guard cleaned, ect...??

are you planning on rivets or screws??

if rivets, how do you plan on setting them??

any machine tools??

just trying to figure out where your at here.